SHERCO 125 User Manual

13
ST SERIES
CHASSIS
2.2 Brake disc change
• As changing front brake disc, during assembling
apply medium threadlocker ( Loctite 243 ) on the
screws and tighten them to a 12Nm torque..
Reassemble the wheel following the
reverse procedure , applying a thin coat
of grease on the wheel spindle.
2.3 Swingarm bearings check
• Undo the nut on the bottom part of the
swingarm and remove linkage shaft.
• Unlock swingarm spindle 1 and remove it.
Linkage shaft tightening torque :
40 Nm
Swingarm spindle tightening torque :
50 Nm
• Remove swingarm and take the two
intern spacers 2 out.
1
1
2

SHERCO 125 Specifications

General

Starter	Kick starter
Bore x Stroke	54 mm x 54.5 mm
Cooling System	Liquid
Transmission	6-speed
Front Brake	Disc
Rear Brake	Disc
Displacement	124.8 cc