SHERCO 125 User Manual

12
ST SERIES
CAUTION
Using a vernier caliper, check intern spacer’s length and replace it if needed.
Minimum length : 118.5mm
❱❘
Rear end
2.1 Wheel bearings change
• Hold wheel spindle on the left side and undo
the nut on the right side.
• Remove the spindle from the left.
• Remove the wheel and the wheel spacers.
Rear wheel spindle tightening torque :
100 Nm
• Using a heat gun, heat the hub at the bearing
seat.
• Extract bearings using a suitable tool ( ø 20 )
• Replace bearings by new ones .
•

SHERCO 125 Specifications

General

Starter	Kick starter
Bore x Stroke	54 mm x 54.5 mm
Cooling System	Liquid
Transmission	6-speed
Front Brake	Disc
Rear Brake	Disc
Displacement	124.8 cc