SHERCO 125 - ENGINE REMOVAL;FITTING; Engine Removal; Engine Fitting

14
ST SERIES
CHASSIS
• Check the needle bearings of both
sides.. In case of rust, replace them.
Otherwise, apply grease before
reassembling.
• Reassemble the set following the
reverse procedure and applying grease
on swingarm spindle and linkage shafts.
2.4 Suspension linkage check
• Loosen lower suspension shaft 1 and linkage
shafts 2 .
• Loosen the tie-rod screw 3 .
• Remove all the shafts and the linkages.
Remove the linkage inner ring and check
the bushings 4 . In case of wear sign,
replace them by new ones.
Reassemble the set following the reverse
procedure , applying grease on the shafts and
bushings.
• Shock screw tightening torque : 40 Nm
• Linkage shaft tightening torque : 40 Nm
Tie-rod screw tightening torque : 40 Nm
1
2
3
4
2
4