Operating Instructions Chapter 6
C 4000 Standard/Advanced
8 009 861/OE59/19-11-04 © SICK AG • Industrial Safety Systems • Germany • All rights reserved
55
Electrical installation
6.10 Test input (sender test)
The sender test is performed when 0 V is present at the test input (pin 3).
To be able to use the sender test button, you must also configure the Sender test function
with the aid of the CDS: Device symbol C 4000 Host (sender), context menu Configuration
draft, Edit, option Enable sender test.
If you do not connect the test input, then you must deactivate the Sender test function
with the aid of the CDS. Otherwise, the safety light curtain remains permanently red.
6.11 Intelliface applications
Using Intelliface, the intelligent interface technology for safety systems, SICK provides you
with an entire range of interface products that were specially developed for interfacing
safety products and machines.
For complex applications the C 4000 can be integrated into UE 100 Intelliface family
safety systems. In this way the functions of the safety light curtain can be enhanced and
corresponding applications realised.
All C 4000 Standard/Advanced variants are equipped with an EFI (safe SICK device com-
munication). All safety-relevant signals are transmitted using this interface. A bus interface
to a safe fieldbus is possible using the series UE 1000 Intelliface device family.
You will find example circuits in the operating instructions for the series UE 100 and
UE 1000.
Fig. 36: Connection of the
sender test button
!
Note
Note
24 V DC
Pin 3
Sender test control, e.g.
using button
#"
To Next Page
Loading...
