EasyManuals Logo

SICK DUSTHUNTER T User Manual

SICK DUSTHUNTER T
552 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
Important Information
GMS800 · Operating Instructions · 8013025 V1.2 · © SICK MAIHAK GmbH 9
Subject to change without notice
1.2 Main operating information
Start-up:
b
Ensure leak tightness of gas paths (e.g. filters, valves).
If leaks are suspected: Carry out a leak tightness check(
p. 54, §8.4).
b
Prevent condensation in the sample gas path of the gas analyzer.
b
Make an adjustment after each start-up (
p. 39, §6).
Additionally in potentially explosive atmospheres:
b
Make sure the enclosure is tightly closed.
b
When the GMS800 is fitted with enclosure purging or enclosure pressurization: Pre-
purge the enclosure when stipulated in the device specifications (
Supplementary
Operating Instructions for Enclosure or Operating Instructions for Enclosure Pressur-
ization System).
Operating state:
b
Pay attention to status and malfunction fields
(
Operating Instructions for Control
Unit).
b
Make adjustments at regular intervals (
p. 39, §6).
If an “Alarm” message is displayed:
b
Check the current measured values. Consider the situation.
b
Perform the measures planned at your site for the particular situation.
b
When necessary: Switch the alarm message off (“acknowledge” ).
In hazardous situations:
b
Switch-off the emergency switch or main switch of the host system.
Shutting down:
b
Before shutting down: Purge the sample gas path with a dry neutral gas to prevent
condensation in the measuring system.
1.3 General safety information
Sensitive electronics
Before signal connections are established (also with plug connections):
b
Disconnect the GMS800 and all connected devices from the mains (switch off).
Otherwise the internal electronics could be damaged.
Hazards during maintenance work
b
If it is necessary to open the device for setting or repair: Disconnect the device from all
power sources before starting work.
b
If the open device must be live during work: This work must be performed by skilled
persons who are familiar with potential hazards. If it is necessary to remove or open
internal components, live parts could be exposed.
Never interrupt protective conductor connections.
Hazards due to unsafe state
b
If severe damage is visible on or in the device: Shut device down and secure against
unauthorized start-up.
b
If liquids or particles have penetrated the enclosure: Shut device down immediately
and disconnect mains voltage at external source.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SICK DUSTHUNTER T and is the answer not in the manual?

SICK DUSTHUNTER T Specifications

General IconGeneral
BrandSICK
ModelDUSTHUNTER T
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals