3) Description
â‘ How to use Key
-. There are two ways. One is to use ‘ Keypad’ provided on the front-right side
of the ‘ Data Logger’ , and the other is to use Keyboard (PS2 type) provided
as an option.
-. To use ‘ Keyboard’ , connect the ‘ Keyboard (PS2 type)’ to interface of the
‘ CPU part’ on the left at the back of the ‘ Data Logger’ . Then, place the
‘ KP/KB’ switch to ‘ KB’ .
-. To use ‘ Keypad’ , make sure to place ‘ KP/KB’ switch to ‘ KP’ . NOTE:
Alphabet (‘ A-Z’ , ’ a-z’ ) and other special characters (!, @, #, $, %, ^, &,
* , etc) which are not on Keypad are not allowed to use.
-. Select the menu by using ‘ Function Key’ on the screen.
-. To input setup values, you can change the value by using arrow (t,u).
â‘¡ Menu Description
A. F1: WATCH
-. Go to OVERVIEW screen that displays all measuring data and status of
item from one Stack.
B. F2: SYSTEM
-. Go to screen for change system function and configuration.
C. F3: COM-PORT
-. Go to screen for change communication object setups and protocol.
D. F4: CLOCK
-. Go to screen for change date and time.
E. F5: ITEM
-. Go to screen for change measuring item setup and input variables of
each item.
F. F8: PASSWORD
-. Go to screen for change password.
G. AF10 (Alt-F10): Exit
-. To complete functions and save current status of the system, you may
execute this before turn off the system power.
To Next Page
Loading...
Need help?
General
