8014868/YEF7/2014-09-02 • © SICK AG • Subject to change without notice 11
Operating instructions Distance sensors Dx35
Safety
2 Safety
2.1 Intended use
The DS35 and DT35 distance sensors are opto-electronic sensors for
performing non-contact distance measurement of objects.
The DL35 and DR35 distance sensors are opto-electronic sensors for
performing non-contact distance measurement on reective tape.
SICK AG assumes no liability for losses or damage arising from the use of
the product, either directly or indirectly. This applies in particular to use of
the product that does not conform to its intended purpose and is neither
described nor mentioned in this documentation.
2.2 Incorrect use
DS35, DT35, DL35, and DR35 distance sensors do not constitute safety
components in accordance with the EC Machinery Directive (2006/42/EC).
The distance sensors must not be used in areas where explosions are
possible.
Any other use that is not described as intended use is prohibited.
Never install or connect accessories if their quantity and composition are
not clearly specied, or if they have not been approved by SICK AG.
WARNING
Danger due to incorrect use!
Any incorrect use can result in dangerous situations.
For this reason:
• Distance sensors should be used only according to
intended use.
• All information in these operating instructions must be
strictly complied with.
To Next Page
Loading...
Need help?
General
