8014868/YEF7/2014-09-02 • © SICK AG • Subject to change without notice 27
Operating instructions Distance sensors Dx35
Commissioning
8 Commissioning
Pushbutton damage
NOTICE
Improper operation of the pushbuttons may damage
them!
Improperly operating the pushbuttons may damage
them. This will make operation difcult or impossible.
Damage may negatively affect the enclosure rating.
For this reason:
• Operate the pushbuttons only with your ngers or
a suitable aid.
• Do not operate the pushbuttons using sharp or hard
objects.
→ For an overview of the various setup options, see Page 65, Chap-
ter 15.
8.1 Performing teach-in
NOTE
Teach mode automatically ends if no pushbuttons have
been pressed for 5 minutes.
NOTE
For the DT35 and DL35 distance sensors, for the
Q2 output, you can select a current, voltage,
or switching output. The correct output must be
selected before performing the teach procedure.
→ See Page 36, Chapter 8.5.
NOTE
The hysteresis is preset to 25 mm and can be adjusted
only via IO-Link.
To Next Page
Loading...
Need help?
General
