SICK Dx35 User Manual

8014868/YEF7/2014-09-02 • © SICK AG • Subject to change without notice 31
Operating instructions Distance sensors Dx35
Commissioning
Example: Window teach is to be performed for the Q1 switching output.
1. Position object at teach point 2.
2. Press and hold the select pushbutton for longer than 5 seconds. The
Q1 near LED lights up.
3. Press the set pushbutton.
If the teach was successful, the setting is applied immediately. The Q1
and Q2 LEDs ash twice simultaneously. If the teach was not success-
ful, the Q1 and Q2 LEDs ash alternately.
4. If necessary, perform ne teach. → See Page 34, Chapter 8.3.
5. Position object at teach point 1.
6. Press the select pushbutton. The Q1 far LED lights up.
Press the set pushbutton.
If the teach was successful, the setting is applied immediately.
The Q1 and Q2 LEDs ash twice simultaneously. If the teach was not
successful, the Q1 and Q2 LEDs ash alternately.
7. If necessary, perform ne teach. → See Page 34, Chapter 8.3.
8. In order to leave teach mode, either press and hold the select
pushbutton longer than 5 seconds or wait 5 minutes without pressing
the pushbuttons.

SICK Dx35 Specifications

General

Brand	SICK
Model	Dx35
Category	Accessories
Language	English