SICK EtherNet/IP microScan3 - Monitoring Cases; Settings for Monitoring Case Tables

7.15 Monitoring cases
Overview
Figure 71: Monitoring cases
1
Add monitoring case table
2
Configured field sets
3
Settings for the whole monitoring case table
4
Settings for the individual monitoring case
5
Input conditions for a monitoring case
6
Field set in the monitoring case and in the cut-off path
7
Cut-off paths
8
Areas for defined cut-off behavior
9
Remove field set from a monitoring case
In the monitoring case editor, you can also define the monitoring cases with input
condit
ions and assign the field sets.
Further topics
•
"Monit
oring case", page 21
7.15.1 Settings for monitoring case tables
Name
In t
he Name field, enter a name for the monitoring case table that is as descriptive as
possible.
7 C
ONFIGURATION
122
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/1NTM/2024-06-03 | SICK
Subject to change without notice