7.14 Inputs and outputs
Overview
Figure 70: Inputs and outputs
1
Use an input source
2
Input for switching between monitoring cases
3
Restart behavior of the network outputs
4
Input for speed
5
Behavior on connection termination
6
Network outputs
7
Input for additional functions
Safety Designer provides a selection of the possible signal inputs.
Use one input source
Y
ou can specify that the same source is used for all inputs.
Monitoring case switching
If y
ou want to switch between different monitoring cases, then specify which source is
used.
If the source contains static control inputs, then also define the evaluation of the
static control inputs:
•
Complementary
7 C
ONFIGURATION
120
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/1NTM/2024-06-03 | SICK
Subject to change without notice
To Next Page
Loading...
