7.5 Network settings
7.5.1 EtherNet/IP
Overview
Figure 59: Network settings: EtherNet/IP
1
Values in the project
2
Values in the device
3
Buttons to read or transmit values
NOTE
If a de
vice has already been configured, the entire configuration will be transmitted
from the project to the device when the IP settings are changed. The configuration of
the control may also be invalid.
►
Before changing the IP settings: Read the configuration from the device using
Safety Designer and save if necessary.
IP address:
If communic
ation between the device and a controller or a computer will be established
via TCP/IP, please enter the IP settings here.
►
Enter IP adress, Subnet and, if applicable, Router.
CONFIGURATION 7
8020200/1NTM/2024-06-03 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™
97
Subject to change without notice
To Next Page
Loading...
