SICK EtherNet/IP microScan3 - Switching on

Figure 76: Alignment about the transverse axis
Figure 77: Alignment about the depth axis
►
Af
ter alignment, tighten the screws with the specified tightening torque.
8.3 Switching on
After switching on, the device performs various internal tests. The OFF LED illuminates
c
ontinually. The ON LED is off.
When switched on for the first time, the startup process can take up to 100seconds.
When switching on again, the required startup time depends on the volume of configu‐
ration data. The startup process then takes about 10 to 30seconds.
8 C
OMMISSIONING
140
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/1NTM/2024-06-03 | SICK
Subject to change without notice