6 COMMISSIONING
8022965-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
Subject to change without notice
▸
Change the IP address of the configuration PC to the address range of the connected
2D LiDAR sensors.
▸
Click on the Search settings button. The Connection Wizard helps you establish
a connection to a connected device.
▸
Select the Search using device family option and click Next to confirm.
• Limit the list to the LMS4000 family and click Next to confirm.
▸
Click Next to confirm each of the configured search settings, and click Finish to
complete.
Adjusting the IP
address of the first
LMS4x21
Starting the
device search
To Next Page
Loading...