Siemens ADVIA 1800 - System Test List Window; Analysis Order Set Window; Analytical Parameters (Serum) Window

62 ADVIA 1800 Operator’s Guide
♦
Type
♦
Container name
♦ Container diameters ♦ Container heights
♦
LLS sensitivity
♦
Liq volume judge
• Reagent bottles
The settings below specify the reagent bottles used by the system. These settings are used in
the Reagent Inventory, Reagent Container Set, and Lamp Energy Monitor windows.
CAUTION
Incorrect settings may result in abnormal data.
♦
Type
♦
Container name
♦ Bottle section ♦ LLS sensitivity
System Test List window
Perform any of the following tasks at this window:
• Add tests that are used regularly by your system. The tests on the list appear on other
windows
• Assign a reagent tray position number for non-barcoded reagents or a reagent code (R-
Code) for barcoded reagents
CAUTION
Do not modify the order
of the tests on the System Test List window after
initial setup. If you reposition any tests on the System Test List window after
initial setup, results for samples already run could be associated with the wrong
test name.
Perform any of the following tasks at this window:
• add tests to list
• remove tests from list
• set the test processing order
Analysis Order Set window
Use this window to set the order in which tests on the list run. To run tests in the order
they displays at the System Test List window, you do not need to use this window.
• print test list items
• assign reagent codes or position numbers
Analytical Parameters (Serum) window*
Use this window to set the parameters for evaluating the serum indices (lipemia,
hemolysis, and icterus).
Perform any of the following tasks at this window:
• define up to five different flagging levels of concern for each serum indices
NOTE: Operation of the serum indices feature is controlled in the Serum set area of the
System Specifications Set window.