System Overview 71
2 Operating the System
Start the System
NOTE: Before you start operating the system, please read the Additional Operating
Instruction section on page 99.
Logging on
There are 4 access levels to the system software:
Level Password Comment
user no Intended for routine operation
supervisor yes
Access to some system setup and advanced
maintenance features
tech_manager yes
Access to most system setup and advanced
maintenance features
You have to contact your technical service
provider or distributor in order to change the
default settings on these windows.
service yes Access for Siemens service personnel
You are automatically logged on at the user level during startup. No operator is required.
If you log on at the supervisor or tech_manager levels, when done, you should log on to
the user level (no password required).
Starting the system
BIOHAZARD
Before you turn on the system, verify that waste drain is not clogged. Clogging of
the drain could result in a potential biohazard.
WARNINGS
• Keep all covers and safety shields in place during system operation to avoid
injury or infection.
• When starting up the system, be sure to follow all instructions correctly to avoid
loss of data.
CAUTIONS
• Do not use excessive force when opening and closing covers to avoid damage to
the hinges.
• Make sure that all probes and washers are free to move without any obstruction
to avoid damage to the analyzer.
To Next Page
Loading...
