Siemens CIM - Page 116

Technical specifications
9.2 Certificates and approvals
CIM
116 Operating Manual, 11/2022, A5E51250518-AC
UL file: E472610
Installation Instructions for cULus haz.loc.
• WARNING – Explosion Hazard – Do not disconnect while circuit is live unless area is known
to be non-hazardous.
• WARNING - Explosion Hazard - Substitution of components may impair suitability for Class
I, Division 2 or Zone 2.
• This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class I, Zone 2,
Group IIC; or non-hazardous locations.
• Antenna must be installed within the end use enclosure. Routing and remote installation
(not evaluated as part of this certification) of the antenna shall be in accordance with the
appropriate location regulations when installed in unclassified and/or Class I, Division 2
Hazardous Locations.
FM
Factory Mutual Research (FM) in accordance with
Approval Standard Class Number 3611, 3600, 3810
ANSI/UL61010-1, ANSI/UL 121201
CAN/CSA-C22.2 No. 0-10
CSA C22.2 No. 213
CAN/CSA-C22.2 No. 61010-1
APPROVED for use in Class I, Division 2, Group A, B, C, D T4;
Class I, Zone 2, Group IIC Tx
Installation Instructions for FM
• WARNING – Explosion Hazard – Do not disconnect while circuit is live unless area is
known to be non-hazardous.
• WARNING - Explosion Hazard - Substitution of components may impair suitability for Class
I, Division 2 or Zone 2.
• This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class I, Zone 2,
Group IIC; or non-hazardous locations.
IECEx
The CIM meet the requirements of explosion protection according to IECEx.
IECEx classification: Ex ec IIC T4 Gc
IECEx certificate: IECEx UL 22.0089X