Siemens CIM - System Configuration Management; System Upgrade

Web-based configuration
5.4 Web pages
CIM
86 Operating Manual, 11/2022, A5E51250518-AC
Factory reset
When you press the "Factory Reset" button, web-based configuration reset the connected CIM
to factory setting.
Note
Before factory reset, backup the configuration data through the path
System Setting -->
System Configuration Management
.
Built
-in certificate (Page 78) and SMS center number (Page 76) will be kept after the factory
reset.
5.4.10.5 System configuration management
This function allows you export the current CIM configuration or import a CIM configuration
file to CIM.
Export configure file
1. Click the button "Export Configure File".
2. Enable or disable "Protect file with password" and set the password if you want to protect
the configuration file from casual use.
Note
The following configuration will not be exported:
•
IP address
•
Password
•
Certificate
•
Key
•
Clock
Import configure file
1. Click the button "Import Configure File".
2. Navigate to the folder in which you saved the configure file and select it.
3. Enter the password if the configuration file is protected.
5.4.10.6 System upgrade
This page allows you upgrade the firmware for CIM.