Siemens CIM - Contacts

Web-based configuration
5.4 Web pages
CIM
54 Operating Manual, 11/2022, A5E51250518-AC
5.4.5 Contacts
In this table, you can configure the contacts for sending or receiving SMS messages. You can
add a maximum of 16 contacts for CIM.
Add a contact
1. Click "Add Row".
2. Enter the "Name" and "Phone Number" of the contact.
Name: A name can contain letters, numbers and special characters.
Phone number: Phone number through which the user can be reached.
IPv6 Notify: Notify the contact if the IP address for IPv6 is changed.
IPv4 Notify: Notify the contact if the IP address for IPv4 is changed.
Note
When you enter an international number, use "+" as the exit code. For example, "+86".
The contact name must be unique.
3. Repeat step 2 to add all the contacts as you need.
4. Click "Save Changes" to save the change or click "Discard Changes" and "Confirm" to discard
the change.
Note
If the message is referred by event, action or power on/off, the message cannot be edited or
deleted.
Change a contact
1. Click for the contact you want to edit, then enter the new value directly.
Delete a contact
1. Click for the contact you want to delete.