Calling the PipeSpec Designer
4
Procedure
1.
Select the type of project from which you want to call the PipeSpec Designer:
– To work with a pipe spec across projects, open the base project.
– To work with a pipe spec exclusively in one engineering project, open the relevant
engineering project.
2. Select the command "Administrator > Base data > Pipe specs" in the menu bar.
Result
The "Pipe spec administration" tab of the PipeSpec Designer opens in the working area. Before
any pipe specs are loaded, this tab is still empty.
See also
Loading a pipe spec in PipeSpec Designer
(Page 71)
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA 69
To Next Page
Loading...
