Siemens COMOS - System Information Tab; Data Maintenance Tab; Fabrication Tab; Comments Tab

3.5.12 "System information" tab
The tab is used in the Isometrics module.
3.5.13
"Data maintenance" tab
The tab is used for data management.
3.5.14 "Fabrication" tab
The tab is used in the Isometrics module.
You can find more information on this topic in the "Isometrics" manual, keyword "Adapting
dimensions".
3.5.15 "Comments" tab
You can enter remarks about the pipe part here.
3.5.16 "3D geometry" tab
The attributes of the tab are of importance for pipe spec administration and for the generation
of 3D objects.
Setting for all 3D attributes
3D mode must be activated for all 3D attributes:
Properties of the attribute, "Link" tab, "Mode": "On"
3.5.16.1 "General" control group
The "3D geometry" tab has the following general geometry attributes:
Control element Description
"Standard"
● Displays the selected system of standards.
●
Linked to "Y00T00060.Y00A00038 NSys"
"In the report, only use
the symbol for the re‐
quirement"
Option which is relevant for P&IDs if the P&ID catalog is linked to the pipe
part catalog. See also chapter
Retaining the request as the report object
(Page 130).
Preparing for creation and maintenance of pipe specs
3.5 Administering pipe part catalogs
PipeSpec Designer
50 Operating Manual, 09/2014, A5E32076948-AA