"Norm description" control group
Description Function
"Technical norm"
● Dependent on the system of standards
"Company standard"
● Refers to a company standard.
"NSys"
● Displays the selected system of standards
●
Linked to the "Y00T00060.Y00A00038 NSys" attribute
"Geometry description" control group
Control element Description
"PN"
● Script block "OnChange()":
Purpose: Forwarding of a new nominal pressure to the
"Y00T00050AA01.Y00A00090 Nominal pressure" attribute
See also
Change DisplayValue()
(Page 149)
3.5.7 "Part specification" tab
The control elements that are not self-explanatory are described below.
See also
Change DisplayValue() (Page 149)
3.5.7.1 Control group "Pressure/temperature dependency"
Purpose
The table stores the information on the temperature at which nominal pressure is allowed for
a pipe part.
The values entered here are evaluated on the "Chart" tab in the PipeSpec Designer and
displayed in a diagram. See also chapter "Chart" tab (Page 108).
Preparing for creation and maintenance of pipe specs
3.5 Administering pipe part catalogs
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA 45
To Next Page
Loading...
