Siemens COMOS - Dimensions Tab at Bolt Step Lengths; Dimensions Tab at Nuts

● "WT <kg>" column:
Purpose: Weight of the washer
●
"M" column:
Purpose: The height of the washer
3.4.5 "Dimensions" tab at bolt step lengths
Path in the database: "@40 > A20 > Y00 > A10 > A30 > Y00T00055 > A03 > B02 > C05 >
Y00T00055 Dimensions"
Inheritance source for the tab in which you enter the weights and material numbers of the bolts
at the geometry tables in the "Standard geometry tables" standard catalog.
The actual dimensions are input at the lowest level of the standard geometry tables.
Table
● Purpose: Specifies the bolt step lengths by geometry standard. Remains blank at the
standardization.
● Display properties:
"Row display": "Extend dynamically", as otherwise you cannot update the table
subsequently in order to add new rows.
● "WT" column:
Purpose: Here, you enter the weight at the basic tables in the "standard geometry tables"
standard catalog.
● "ID" column:
Here, you enter the material number at the basic tables in the "standard geometry tables"
standard catalog.
● Column: "L1 <mm>"
Purpose: Here you define the bolt lengths permitted in the geometry standards.
3.4.6 "Dimensions" tab at nuts
Path in the database: "@40 > A20 > Y00 > A10 > A30 > Y00T00055 > A03 > B02 > C02 >
Y00T00055 Dimensions"
Purpose:
Purpose: Defines the geometry parameters for nuts
Inheritance source for the tab in which you enter the nut height, protrusion, and slope in the
"Standard geometry tables" standard catalog.
The actual dimensions are input at the lowest level of the standard geometry tables.
Preparing for creation and maintenance of pipe specs
3.4 Managing the "standard geometry tables" standard catalog
PipeSpec Designer
26 Operating Manual, 09/2014, A5E32076948-AA