Content
Some of the information on the tab is preconfigured in the database. It has the following
attributes:
Attribute Function
"Function code"
● Specifies that the base object defines a pipe spec.
●
Value: "Pipe spec"
● Do not change the value.
"Base object for pipes"
● Defines
which base object is used for the first layer of the pipe structure.
Overwrites the corresponding project property. See the "COMOS
Administration" manual, keyword "Base object for pipe".
● If no link is set, the base object set in the project properties is used.
"Base object for pipe sec‐
tion"
As above.
"PipePart Finder" -
"XML file" For an imported pipe spec: The path to the file from which the pipe spec
was read.
8.12 Using bolt sets in pipe specs
8.12.1
Overview of using bolt sets
Requirement
● The required bolt sets are available in the base data. See also chapter Creating a bolt set
(Page 64).
● The information for the bolt sets is stored in the <1-n> tab at the pipe parts in the pipe part
catalog or at the pipe spec elements. The control groups of the required bolt circles are
completely filled except for the "Bolt set" field. See also chapter Assigning bolt sets to a
pipe part (Page 39).
Workflow
1. Define the characteristics for the strength grades of bolts and nuts in the pipe spec.
See also chapter Defining the strength grades of screws and nuts (Page 111).
2. Add the bolt set to the pipe spec and define the nominal diameter range within which the
bolt set is available.
See also chapter Adding a bolt set to the pipe spec (Page 111).
Configuring pipe specs
8.12 Using bolt sets in pipe specs
PipeSpec Designer
110 Operating Manual, 09/2014, A5E32076948-AA
To Next Page
Loading...
