Result
The 3D view opens. All 3D objects located underneath the object selected in the Navigator
are rolled out in the 3D view with all nominal diameters:
●
Pipe parts with one nominal diameter:
X axis: The pipe parts that have been analyzed
Y axis: The nominal diameters for which the geometry has been calculated
For each pipe part: For each nominal diameter
● Pipe parts with two nominal diameters:
12.5.4 Switch to detail evaluation
Initial situation
If the geometry of a pipe part has not been calculated in the bulk analysis, you can switch to
the detail evaluation and analyze the reason for this.
"Error analysis for 3D objects" plugin
12.5 Nominal-diameter-dependent check of the geometry
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA 143
To Next Page
Loading...
