Procedure
1.
Open the node of the required object in the results table on the "Bulk analysis" tab.
2. Click with the left mouse button on the nominal diameter for which you want to start the
detail analysis.
3. Select "Check values" from the context menu.
– The "Detail evaluation" tab opens.
– The
settings for pipe spec and nominal diameter of the object to be analyzed are applied.
4. Click the "Calculate" button to start the evaluation.
"Error analysis for 3D objects" plugin
12.5 Nominal-diameter-dependent check of the geometry
PipeSpec Designer
144 Operating Manual, 09/2014, A5E32076948-AA
To Next Page
Loading...
