Standard table for screw lengths
●
Standard tables in the database:
– DIN/EN:
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A20 Bolt length"
– ANSI/ASME
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A20 Bolt length"
Similar to the standard table for nominal diameters, the following applies:
– New values are appended to the end of the list.
– Do not move or delete existing entries.
● The standard table is used in the following places:
– In the "standard geometry tables" standard catalog
"@30 > M23 > A10 > Y30 > A10 Standard geometry tables"
– At the bolts, nuts, and washers in the pipe part catalog.
Standard table of strength grades for screws and nuts
● Standard table in the database:
– DIN/EN:
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A30 Strength grade bolts acc
DIN2507"
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A40 Strength grade nuts acc
ISO 898-2"
– ANSI/ASME:
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A30 Property classes of bolts
according to ASME"
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A40 Property classes of nuts
according to ASME"
● The standard table is used in the following places:
– In the PipeSpec Designer on the "Characteristics" tab.
– In the properties of screws and nuts, "Attributes > Part description" tab.
Standard table for bolted types
● Standard table in the database:
"Standard tables > Y10 > M23 > A20 > Y10M23N00028 Bolted types"
● The standard table is used in the flanges of the pipe part catalog, on the "3D geometry" tab.
Preparing for creation and maintenance of pipe specs
3.8 Preparing bolt sets
PipeSpec Designer
68 Operating Manual, 09/2014, A5E32076948-AA
To Next Page
Loading...
