7 Operation at Use of a PC
7.3 Configuration of the Device
107SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
7.3.1.1 Get Device Configuration
If you have selected Get device configuration in the Configure tab, you can open and edit either the Get
active configuration or the Get default configuration in the input/output window. Proceed as follows:
Figure 7-11 Configure Tab, Get Device Configuration
Get Active Configuration and Editing
✧ Click Get active configuration.
A copy
of the active set of parameters (= passive set of parameters) of the device is opened for editing.
✧ Check and, if necessary, change the set parameters by opening the desired menus in the navigation
window:
Operational parameters menu according to Setting the Operational Parameters
Display settings according to HMI
PQ Management according to Recording and Reporting
Administrative menu according to Setting Administrative Parameters.
✧ Activate the modified configuration as described in Finish Configuration.
NOTE
If you have selected Get device configuration, an editable copy of the active parameter set of the device is
displayed on the screen. In the meantime, the active parameter set in the device continues to operate.
If you have selected Open configuration from file, you can open and enable or edit the copy of a parameter
set that was already created and saved to a folder.
To Next Page
Loading...
