7 Operation at Use of a PC
7.3 Configuration of the Device
108 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Get Default Configuration and Editing
✧ Click Get default configuration.
A copy
of the factory settings (= passive set of parameters) of the device is opened for editing.
✧ Activate the modified configuration as described in Finish Configuration.
7.3.1.2 Open Configuration from File
If you have selected Open configuration from file in the Configure tab, you can open an already existing file
in a folder. Proceed as follows:
Figure 7-12 Configure Tab, Open Configuration from File
✧ Click Browse....
NOTE
You can edit the displayed factory settings, activate and use them as active set of parameters. The original
factory settings are not overwritten and can be used at anytime.
To Next Page
Loading...
