7 Operation at Use of a PC
7.3 Configuration of the Device
118 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
✧ If you are not using a voltage transformer and/or current transformer between the measurement object
and SENTRON PAC5100/5200, click no in the respective option field. The associated fields for primary
and secondary values are hidden in this case.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
To Next Page
Loading...
