7 Operation at Use of a PC
7.5 Maintenance
178 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
7.5.3.2 Date/Time
To set the date and time, proceed as follows:
✧ In the navigation window, select the Presets menu and click Date/time.
Figure 7-65 Maintenance Tab, Preset Date/time
✧ You can either get the date and time from the connected computer or adjust it manually.
Get PC Date and Time
✧ In the input/output window, click Get PC date/time.
The computer time is displayed in the fields of the input/output window and applied in the device.
Setting the Date and Time Manually (24-hour format)
✧ In the input/output window enter the desired time into the fields Day (format dd), Month (format mm), Year
(format yyyy), Hour (format hh), and Minute (format mm).
✧ Enter the maintenance password into the Password field.
✧ Click Set Date/time.
The time you have entered is displayed in the fields of the input/output window and applied in the device.
The Action was successful indication is displayed on the status bar.
NOTE
If you want to change the date and time, you have to set the Source time synchronization to Internal on the
Configure Administrative Time synchronization tab.
NOTE
If you want to change the date and time, make sure that any previously set Start record option (Recording
parameters tab) conforms to the newly set time. If the Start record option is earlier than Date/time, no recording
takes place and an error message is output.
To Next Page
Loading...
