Siemens SENTRON PAC5200 - Page 205

8 Operation at Use of the Display
8.4 Parameterization
205SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Submenu Display Number 32.5: Communication
Figure 8-22 Submenu Display Number 32.5, Communication
1)
After the communication parameters have been changed, the device restarts. For this purpose, a prompt
is displayed which you must acknowledge with OK.
32.5
Communication
39.0
IP Address
ENTER
EDIT
39.0
Communication
Ethernet


ENTER
39.0
IP-Addr.
Subnet
Gateway
+
ENTER
39.0
Bus protocol:
- Modbus TCP
- none


EDIT
Select. parameters
acc. to following table
OK
ESC
Select.
bus protocol


EDIT
OK
ESC
Change the para -
meters acc. to
following table
OK
ESC
+
-

NOTE
The MAC address is shown on the display but cannot be edited.
For this purpose, a prompt is displayed which you must acknowledge with OK.
Table 8-5 IP Address Settings
Parameter Default Setting Setting Range
MAC address fixed
IP address
1)
192.168.0.55 Any
0.0.0.0 = DHCP
Subnet
1)
255.255.255.0 Any
Gateway
1)
192.168.0.1 Any