11 Failures and LED Indications
11.3 Indications Signaled by LEDs
222 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Meaning of the LEDs
LED (green, red, yellow): on
LED (green, red, yellow): flashes
LEDs H1/H2/ERROR: according to parameterization
LED: off
LED Speed (yellow):
off: 10 Mbit/s
on: 100 Mbit/s
LED Link/Activity (green):
LED on: Ethernet link is up
LED flashing: Ethernet link is up and data is transferred
LED off: no Ethernet partners connected
NOTE
The designations and functions of the LEDs on the top side and on the display side of the housing are identical.
Therefore, only the LEDs on the top side of the housing are described in the following table.
NOTE
In the following table, the F4 softkey is pressed in order to call the default IP address. Devices without display
have the IP-Addr. push-button located on the DIN rail side, see Chapter 5.7.3, Figure 5-7.
Table 11-1 Indications Signaled by LEDs on the Top Side of the Housing
LED Meaning
Device switched off
No firmware loaded
To Next Page
Loading...
