Description
● Status
Shows the status of the KEY-PLUG. The following are possible:
– ACCEPTED
There is a KEY-PLUG with a valid and matching license in the device.
– NOT ACCEPTED
The license of the inserted KEY-PLUG is not valid.
– NOT PRESENT
No KEY-PLUG is inserted in the device.
– MISSING
There is no KEY-PLUG inserted with the "FACTORY" status. Functions are configured
on the device for which a license is required.
– WRONG
The inserted KEY-PLUG is not suitable for the device.
– UNKNOWN
Unknown content of the KEY-PLUG.
– DEFECTIVE
The content of the KEY-PLUG contains errors.
● Order ID
Shows the order ID of the KEY-PLUG. The KEY-PLUG is available for various functional
enhancements and for various target systems.
● Serial Number
Shows the serial number of the KEY-PLUG.
● Info String
Shows additional information about the device that used the KEY-PLUG previously, for
example, article number, type designation, and the versions of the hardware and software.
The displayed software version corresponds to the version in which the configuration was
last changed. With the "NOT ACCEPTED" status, further information on the cause of the
problem is displayed.
Note
When you save the configuration, the information about whether or not a KEY-PLUG was
inserted in the device at the time is also saved. This configuration can then only work if a
KEY-PLUG with the same order number / license is inserted.
Configuring with Web Based Management
4.5 "System" menu
SCALANCE S615 Web Based Management
184 Configuration Manual, 11/2019, C79000-G8976-C388-08
To Next Page
Loading...
Need help?
General
