1 Introduction 03/2013
1.2 Overview of functions
© Siemens AG 2006-2013 All Rights Reserved
1-10 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
1.2 Overview of functions
What is SINUMERIK Integrate Analyze MyCondition?
SINUMERIK Integrate Analyze MyCondition supports the service and maintenance
activities of machine tool manufacturers and manufacturing companies. This is
done with software services that are available in a CNC, S7 control, machine PC,
or work station PC.
This requires both a control on the machine that complies with the specifications,
and Internet access.
The following services are parts of SINUMERIK Integrate:
Remote access
Remote access to the control is performed via a secure Internet infrastructure.
Remote access is performed via Access MyMachine/Ethernet or Access
MyMachine/STEP 7. It provides the following functions:
• Desktop Control
• File Transfer
• Conference
• Session recording
Control monitor services
Recording of events in a history and documentation of the current status of the
control at this point. This allows the status of the device to be analyzed and
compared with earlier states should a fault occur.
The current status of the machine is documented using the following events and
data:
• Alarms, PLC events, time intervals, combinations of machine signals
• Limit value violation and time delay violation from condition monitoring
• Series of measurements/tests and variable monitors
• Manual help request by the machine operator in the event of faults
• HMI action log, machine data, NC status data
• PLC trace, PLC data blocks
• Certain files (e.g. log files) of the control
To Next Page
Loading...
Need help?
General
