Name: Siemens SIMATIC S7-300 Module data
Brand: Siemens
Rating: 4 (1 reviews)

To Next Page

To Previous Page

03/2013 3 Setting up functions

3.2 Configuring measurements and measurement series

SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013

3-103

3.2 Configuring measurements and measurement series

Function description

Configuration of measurements and measurement series it when you define the

parameters required for measurement. The configurations created are always

stored with the measurements and can be used again to repeat the measurements.

That especially applies to measurement series. The configuration of a

measurement series ensures that measurements are made with the same settings

every time. This permits evaluation of the progression of characteristics over time.

In addition to parameters for performing a measurement, the limit values of the

characteristics are also configured. Limit values can be configured for

measurement series. The configuration is only possible on the PC. Individual

measurements that do not belong to a measurement series cannot have limit

values.

Availability and privileges

On the operator panel, a measurement is configured or a measurement series

configuration changed only during the measurement procedure. On the operator

panel, it is only possible to create a measurement series based on a measurement

being performed.

On the PC, it is possible to configure measurement series. The authorization

required to configure measurements and measurement series is described in detail

in the Appendix.

Other manuals for Siemens SIMATIC S7-300 Module data

Questions and Answers:

Need help?

Do you have a question about the Siemens SIMATIC S7-300 Module data and is the answer not in the manual?

General