03/2013 3 Setting up functions
3.6 Copy
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-195
Note
Copying user configurations in SINUMERIK Integrate is only possible when the
device classes (SINUMERIK, S7, IPC) for source and target machine are
identical.
Copying user configurations with an axis reference is only possible in
SINUMERIK Integrate if the axis indices, axis names and measuring system
evaluation (translational or rotational) for source and target machine are identical.
In the case of cross-organizational copying, addresses are extended in the target
machine if this is required by the copied user configurations. This is shown in the
log.
Notice
User configurations that are present on the target machine are overwritten by
copying a configuration with the same name onto it.
User configurations can call other user configurations as configuration.
SINUMERIK Integrate automatically selects these configurations for copying
since the copied user configuration is not functional without these (unless this
user configuration is already available on the target machine).
Example: The "OILING" control monitor maintenance job has the action to output
the "OILING" maintenance schedule. If the "OILING" maintenance schedule is
not present on the target machine, it must be copied onto it so that the control
monitor is able to function correctly. If the "OILING" maintenance schedule exists
in the target machine, it can be copied such that it overwrites the schedule.
However, this is not necessary if you want to use the existing one with the
"OILING" maintenance job control monitor.
To Next Page
Loading...
Need help?
General
