Installation and wiring
3.3 Installing the EIP-200S Ethernet/IP Adapter
EIP-200S Ethernet/IP Adapter Distributed I/O System
54 System Manual, 06/2018, A5E44345053-AB
Installing the EIP-200S Ethernet/IP Adapter
Features
● The EIP-200S Ethernet/IP Adapter connects the ET 200S with the network.
● The EIP-200S Ethernet/IP Adapter transfers data between the higher-level controller and
the I/O modules.
The prerequisites for installation are shown below
● The rail must be installed.
● All the terminal modules must be installed to the right of the interface module. The
maximum configuration of the ET 200S distributed I/O system is 63 modules (including
power modules, I/O modules, motor starters, and terminating module).
3 mm screwdriver
Installing the EIP-200S Ethernet/IP Adapter
To install the EIP-200S Ethernet/IP Adapter, follow the steps below:
1. Hang the interface module on the rail.
2. Tip the interface module back until you hear the locking mechanism engage.
Removing the EIP-200S Ethernet/IP Adapter
The interface module is wired, and the terminal modules are on the right:
1. Switch off the supply voltage on the interface module.
2. Disconnect the wiring connector and the bus connector on the interface module.
3. Use a screwdriver to push the locking mechanism on the interface module down until the
mechanism stops, and move the interface module to the left.
– Note: The locking mechanism is under the interface module.
4. With the locking mechanism depressed, tip the interface module forward so that it comes
off the rail.
To Next Page
Loading...
Need help?
General
