EIP-200S Ethernet/IP Adapter
2.7 Device profile: vendor-specific objects
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB
43
Device profile: vendor-specific objects
2.7.1
The Adapter Object provides the external configuration and monitoring interface to the
EIP-200S Ethernet/IP Adapter.
No attributes are supported for the Adapter Object at the class level.
Instance 1 attributes of the Adapter Object
Adapter Status (see AdapterStatus details table).
Currently configured input assembly size.
Currently configured output assembly size.
4 Get/Set
2
AutoConfig BOOL Automatic Configuration mode
1: Automatic configuration: the rack self-configures
based on the modules installed (factory default).
0: Manual configuration: the rack configuration is
stored in nonvolatile memory.
5 Get ConfigChanged BOOL True if manual configuration changes have been
made but have not taken effect.
6 Get Diagnostic String Array of USINT [65] An array of USINT containing slot diagnostics. The
first byte of the array indicates the number of valid
diagnostic bytes within the array (the remaining
bytes within the array can be ignored).
Indicates the number of configured slot objects.
2
Configuration information for the adapter module.
9 Get/Set
2
IO_StatusEnable BOOL Enables the generation of an I/O status byte at the
beginning of the input data I/O packet.
Factory default = enabled.
2
Parameter bytes for electronic module and adapt-
er module behavior.
2
2
2
2
2
2
2
18 Get/Set
2
HeadParamByte9 USINT
2
To Next Page
Loading...
