Siemens SIMATIC S7 EIP-200S - Use of subassemblies;modules in a Zone 2 hazardous area

General technical specifications
5.3 Use of subassemblies/modules in a Zone 2 hazardous area
EIP-200S Ethernet/IP Adapter Distributed I/O System
98 System Manual, 06/2018, A5E44345053-AB
5.3
Use of subassemblies/modules in a Zone 2 hazardous area
Below you will find important information on the installation of the subassemblies/modules in
a hazardous area.
You can find the list of approved devices/modules on the Siemens Service & Support
Website/ (http://support.automation.siemens.com).
Enter the associated article ID in the search window on the website. See table below for
article IDs by product.
Production location/certification
II 3 G
Ex nA II T3 .. T6
To EN 60079
-15
Test number
see table below
Production location
Subassemblies/ modules
Test number
Article ID
Siemens AG,
Industry Sector
Werner-von-
Siemens-Straße 50
92224 Amberg
ET 200S
ET 200S fault-tolerant modules
ZNX-EIP-200S
KEMA 01
ATEX 1238X
DEKRA 12ATEX0077 X
24037700
S7-300
ET 200M
DP/PA bus interface
Diagnostics repeater
S7-300 fault-tolerant modules
KEMA 02
ATEX 1096X
24038475
PROFIBUS Bus Connector Plug KEMA 04
ATEX 1151X
24028800
S7-1200
TS Adapter IE Basic
KEMA 10
ATEX 0166X
46641616
Siemens AG,
Industry Sector
Őstliche Rhein-
brűcken-straβe 50
76187 Karlsruhe
Germany
S7-400 KEMA 03
ATEX 1125X
21479867
S7-300 CP
TS Adapter II
TS Adapter IE
KEMA 03
ATEX 1128X
214976722
ET 200M Marshalled Termination
Assemblies
KEMA 05
ATEX 1137X
24193554