Product overview
1.3 The EIP-200S Ethernet/IP Adapter
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB
11
The EIP-200S Ethernet/IP Adapter
EIP-200S Ethernet/IP Adapter interface module package
The EIP-200S Ethernet/IP Adapter module package includes as one unit the following listed
components:
● Interface module and terminating module (EIP-200S Ethernet/IP Adapter)
● Companion Disk with EIP ET200 Configuration Tool and EIP ET200 Configuration Tool
User Manual
● Power connector
● SD memory card (6ES7954-8LC03-0AA0)
ZNX-EIP-200S
EIP-200S Ethernet/IP Adapter module features
The EIP-200S Ethernet/IP Adapter is a communications adapter for interfacing to the
Siemens SIMATIC ET 200S distributed I/O system. It provides connectivity between an
Ethernet/IP network and ET 200S power and I/O modules, and has the following features:
● It prepares the data for the electronic modules and motor starters that are fitted.
● It supplies the backplane bus.
● The maximum address space is 255 bytes for inputs and 255 bytes for outputs.
● The reference potential M of the rated supply voltage of the interface module to the rail
(protective conductor) is connected by means of an RC combination, thus permitting an
ungrounded configuration.
● A maximum of 63 modules can be operated with the interface module.
● The maximum width of the station is 1 m. The width can be between 1 m and 2 m, but the
adapter Bus Length parameter must be set to >1 m, and the response time would
increase. See the topic entitled "Parameters" for more information.
● The maximum parameter length for the entire station is 237 bytes.
● Grouping of modules within one byte (packing)
● Device Level Ring (DLR) operation
To Next Page
Loading...
