Siemens SIMATIC S7 EIP-200S - Wiring the EIP-200 S Ethernet;Ip Adapter

Installation and wiring
3.9 Wiring the ET 200S
EIP-200S Ethernet/IP Adapter Distributed I/O System
76 System Manual, 06/2018, A5E44345053-AB
3.9.6
Wiring the EIP-200S Ethernet/IP Adapter
Features
You can connect the supply voltage to the EIP-200S Ethernet/IP Adapter.
Prerequisites
Prerequisites for wiring the EIP-200S Ethernet/IP Adapter are shown below:
● Wire the interface module power connector with the supply voltage switched off.
● Adhere to the wiring rules.
Tool required
3 mm screwdriver