Installation and wiring
3.9 Wiring the ET 200S
EIP-200S Ethernet/IP Adapter Distributed I/O System
System Manual, 06/2018, A5E44345053-AB
77
Wiring the EIP-200S Ethernet/IP Adapter interface module
To connect the supply voltage, follow these steps:
1. Strip the insulation from the wires for the supply voltage of the interface module.
2. Depress the orange wire release slot with a screwdriver and, while holding it down, insert
the stripped wire. Release the wire release slot.
There is a pluggable power connector on the Adapter. The wires are connected to it.
To Next Page
Loading...
