Description of system components
8.3 Operator panel with display
SIMOCODE pro
128 System Manual, 05/2019, A5E40507475002A/RS-AD/004
See Section Read and adapt main display (Page 112).
The temperature from temperature module 1 is always shown in this display profile.
The temperature from temperature module 2 is not shown in this profile.
Voltage display
Switch voltage display: Defines whether "phase voltages" or "line-to-line voltages" will be
displayed (available only with an OPD as from product version *E04* and a
SIMOCODE pro V PB basic unit up to product version *E06*). Configuration is performed in
the basic unit as from SIMOCODE pro V PB basic unit, product version *E07*.
Warnings
Determines whether, in the case of a pending general warning, the display is switched over
to the menu item "Warnings" so that details are displayed (not activated per default):
Do not display (default) - Display
Faults
Determines whether, in the case of a pending general fault, the display is switched over to
the menu item "Faults" so that details are displayed (switched on per default, higher priority
than pending warnings): Do not display - Display (default)
Return to main display
Determines whether and when to return from the current menu to the main display:
Manual, 3 s, 10 s (default), 1 min, 5 min
To Next Page
Loading...
