Description of the motor
2.3 Technical features and environmental conditions
1FW3 complete torque motors
24 Configuration Manual, 08/2020, A5E46027705B AA
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the scope covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the scope covered by the EMC Directive. The products
are not considered as devices in the sense of the directive. Installed and operated with a
converter, the motor - together with the Power Drive System - must comply with the
requirements laid down in the applicable EMC Directive.
European RoHS Directive
The SIMOTICS motor series complies with the Directive 2011/65/EU regarding limiting the
use of certain hazardous substances.
European Directive on Waste Electrical and Electronic Equipment (WEEE)
The SIMOTICS motor series complies with the 2012/19/EU directive on taking back and
recycling waste electrical and electronic equipment.
Eurasian conformity
SIMOTICS motors comply with the requirements of the Russia/Belarus/Kazakhstan (EAC)
customs union.
China Compulsory Certification
SIMOTICS motors do not fall within the scope covered by the China Compulsory
Certification (CCC).
CCC negative certification:
CCC product certification
(https://support.industry.siemens.com/cs/products?search=CCC&dtp=Certificate&mfn=ps&o
=DefaultRankingDesc&pnid=13347&lc)
China RoHS
SIMOTICS motors comply with the China RoHS.
You can find additional information at:
China RoHS (https://support.industry.siemens.com/cs/ww/en/view/109738656)
To Next Page
Loading...
Need help?
General