Siemens SIMOTICS T-1FW3 - Rotating the Connector at the Motor

Electrical connection
8.3 System integration
1FW3 complete torque motors
Configuration Manual, 08/2020, A5E46027705B AA
311
8.3.4 Rotating the connector at the motor
Signal connector and integrated Sensor Module can be rotated to a limited extent.
Note
Observe the following when rotating the connectors:
•
Do not exceed the permissible range of rotation.
•
In order to maintain the degree of protection, max. 10 rotations are permissible.
•
Keep to the maximum rotating torque. See Table "Maximum rotating torques that occur".
•
Only rotate the connector with a mating connector that matches the connector thread.
•
Secure the connection cables against tensile and bending stress.
•
Secure the connector against rotating further.
•
It is not permissible to subject the connector to continuous forces.
Table 8- 5 Maximum rotating torques that occur
Connector
Max. rotating torques that occur [Nm]
Signal connector
8
Integrated Sensor Module
8
Signal cable
The manufacturer mounts the plug-in connection for the signal cable (at the encoder terminal
box).
● When connecting the connector, insert the coding groove into the socket connector until it
is flush and tighten the screw cap by hand as far as it will go.