Note
It is recommended that SIMOTION SCOUT be used exclusively to switch the operating
modes
of the module. Therefore, leave the mode switch at position 0 (RUN). The LED display
indicates the current mode selection.
For information on how to set the operating mode using SIMOTION SCOUT, see the
SIMOTION SCOUT
Configuration Manual.
Service selector switch (V4.1 SP2 and higher)
The following table shows the possible positions of the Service selector switch. The Service
selector switch positions are explained in the order in which they are arranged on the
SIMOTION D4x5.
Table 3-3
Switch positions of the Service selector switch
Service mode Switch position Meaning
- 0 No service/diagnostic functions activated (default setting)
Delete/restore
non-volatile data
1 When the "Delete/restore non-volatile data" switch setting is
selected, the non-volatile data of the D4x5 is first deleted and
then
restored along with the contents of the PMEMORY backup
file.
Downgrade
(device update
tool)
B SIMOTION D4x5 Control Units and projects can be updated
using update data created at an earlier point in time. This
upgrade data is generated with the device update tool (Menu:
"Project>Start device update tool" in SIMOTION SCOUT).
If the upgrade process fails to bring about the desired result,
the upgrade can be rejected by means of the switch position.
This will roll the system back to the previous configuration.
Backing up
diagnostic data
and non-volatile
data
D The diagnostic data and non-volatile data can be backed up in
STOP, STOPU, and RUN modes. The advantage of backing
up in RUN state is the availability of enhanced diagnostic
information (via websites) and TO alarm information.
Additional references
Detailed information
● For
information on setting the operating modes, see the
SIMOTION SCOUT
Configuration
Manual
● For information on upgrading SIMOTION devices (device update tool), see
- Operating Instructions
Upgrading SIMOTION Devices
-
SIMOTION D4x5
Commissioning and Hardware Installation Manual
● For information on creating diagnostic data and backing up/restoring non-volatile data, see
the
SIMOTION D4x5
Commissioning and Hardware Installation Manual.
Operator control (hardware)
3.2 Operator control elements
SIMOTION D4x5
Manual, 04/2014 45
To Next Page
Loading...
