Siemens SINAMICS G180 - Use of Tested, Certified, and Siemens-Approved Components

Safety information
2.2 Use of tested, certified and Siemens-approved components
Installation and Operating Instructions SINAMICS G180
14 Operating Instructions, 02/2019, 4BS0751-007
2.2
Use of tested, certified and Siemens-approved components
Observe the following instructions if you would like to integrate your own components in the
system.
WARNING
Components which are not approved
It is dangerous to use components which are not tested, not certified and not approved by
Siemens. This can result in death, serious injury or material damage.
• Use only components which are tested, certified and approved by Siemens.