Operation
8.8 Examples / Applications
Installation and Operating Instructions SINAMICS G180
170 Operating Instructions, 02/2019, 4BS0751-007
Control cable terminals "peripheral board 3"
Remove the jumper if these control cable terminals are in use.
-X2:3: Four-way distribution terminal for 24 V, -X2:17, 18: Not assigned
In the case of an equipped peripheral board 3 / 4, the supply of the digital inputs -X2:8 … 16 is changed over. The
digital inputs are supplied from -X2:1/3 instead of -X2:51/55.
Figure 8-34 Control cable terminals for "peripheral board 3" application
To Next Page
Loading...
