Operation
8.8 Examples / Applications
Installation and Operating Instructions SINAMICS G180
176 Operating Instructions, 02/2019, 4BS0751-007
"Global" = functional for "Test" and "Normal"
If you use these inputs, remove the jumper.
As long as "P-INTERFACE: Reset-Source" is set to "Global" , all reset sources are always effective.
Max. current load of the control voltages:
• + 24 V DC, potential 2: 300 mA
• + 15 V DC, potential 2: 150 mA ± 10 mA
This voltage can also supply a speed encoder connected at terminal -X101.
Figure 8-36 Control cable terminals for "NAMUR" application
To Next Page
Loading...
